End Pin PLug Bone

Part # Price Purchase
BoneEPPlug/527-8 $ 39.95

One piece cattle bone end pin plug measuring 1/2" diameter on the shaft with a decorative head. Your plug will be made to order here in our pin shop in Dover, Ohio. To order just purchase this item and then email us through our contact page to let us know what inlay you desire.

We can make this pin plug with no inlay (plain head) or we offer inlays of black dot, faux tortoise, Padauk wood (reddish brown wood) or abalone in 4 mm diameter so let us know what you would like! If we do not hear from you we will send the plain head (No inlay) because that is the most popular.

More information:

- Nearly all pickups are installed by reaming the end block to 1/2" This bone plug is machined to 1/2" and can be sanded as necessary if your hole is a bit smaller. If your hole is reamed slightly oversize, (or was aggressively reamed) the plug can be wrapped with a layer of your average clear tape and it will increase the diameter by .004 for each layer.

- The plug section is about .750" long and will firmly support your guitar and not damage the end block.

- The end pin plug should be glued in place with a small amount of wood glue. If you want to remove it at some point it can be gently tapped out from the inside. If you want to make it permanent you can cover the plug's shaft with glue. At this point however you'll need to drill and re-ream the hole if you want it removed.

- This pin-plug is created with a skirt/flange which is designed to cover the impression sometimes made by the washer used in the end pin jack of your former pickup.